Japanese

Real Paper model
MITSUBISHI-FTO
FTO_FRONT
FTO_REAR
To reproduce the FTO's unique curved surfaces as closely as possible, there are many parts, and to successfully construct it, you will need a lot of skill and patience. Also, the headlights and window panes make use of transparent parts of OHP sheet, and perfectly recreating the cockpit is exceptionally difficult/frustrating. (sweat)
For those with free time and persistence, I highly recommend this challenge.
Other builders will struggle with this one.


download
600dpi
parts 		300dpi
parts
assembly
300dpi clear parts(Page 17 only)
parts 54.2KB
Attention!! File size is big.
Parts is 8.26MB(600dpi)/1.49MB(300dpi)/Assembly is 1.12MB

A necessary tools
  • Paper (EPSON PM mat paper is recommended.)
  • OHP Seat (It is used for the reappearance of the transparency part.) for the printer
  • Cutter (An art knife is recommended.)
  • Cutting board (a plastic sheet for the cutter)
  • Adhesive (A bond for the woodwork is recommended.)
  • scraper(Adhesive is applied thinly equally.)
  • Tweezers
  • Ruler (The small thing of about 20cm is easy to spend.)
The tool which is useful when it is here
  • metal tongs
  • Toothpick (when a detailed part sticks, when it is used as scraper substitute, convenience)
  • Eraser (The side of the tire and the spherical surface of the light are used for a base substitute to express it.)
  • The pen (A cubic effect is provided by pressing a part from the top of the eraser.) whose point is round
  • Screwdriver (for the work of rounding paper)
  • Rubber bond (G-17) (for the OHP adhesion)

Making technique
When you cut out the line of the parts, cut from the inside of the line to the outside of the line with the scissors.
Doing so, you can avoid cutting too much caused by the thickness of the edge of the scissors.
First you cut out one of the parts roughly with the scissors and adjust the edge of the cutter at a suitable angle while moving the paper by hand.
This will ensure better cutter control.
Clip the straight lines of the parts by using a ruler to be more precise.
For greatest precision all folds should be preceded with indentations by using a ruler and sharp point. It is important not to cut through completely but rather make an easily identifiable line to create a perfect fold.
Make very small cuts at both ends of the red line so these canbe easily identified from reverse side.
Turn the paper over to reverse side with a ruler and make an indentation precisely from one cut to the other. Turn paper again to original side and fold along red line.
When you make the side of the tire, you put the parts face down on the eraser and press it on using a pen with a round point.
Then you can make it more realistic.

To be continued.
An option such as the latter term pattern bumper and spoiler manufactured by the third party is thought to want to prepare for it from now on, too. It is on the reputation because anyway Maniac is it too much and evaluation is an unknown quantity. (;^^A

Presented by ProjectF East
Teiji Murakami All Rights Reserved.